- 10mm wrench
- 12mm wrench
- Flathead screwdriver
- Adjustable wrench
Instructions:
1. Park your Rio on a level surface and turn off the engine.
2. Open the hood and locate the clutch cable bracket. It is located on the driver's side of the engine compartment, near the firewall.
3. Loosen the 10mm bolts that hold the clutch cable bracket in place.
4. Use the flathead screwdriver to pry the clutch cable out of the bracket.
5. Remove the 12mm bolt that holds the clutch release arm to the transmission.
6. Use the adjustable wrench to turn the clutch release arm until the clutch pedal is fully depressed.
7. Hold the clutch release arm in this position and reinstall the 12mm bolt.
8. Reattach the clutch cable to the clutch cable bracket and tighten the 10mm bolts.
9. Start the engine and test the clutch. The clutch should now engage smoothly and without slipping.
