* Wrench set
* Socket set
* Flat-head screwdriver
* Phillips-head screwdriver
* Pliers
* Funnel
* Coolant
* Rags
Instructions:
1. Park your car on a level surface and turn off the engine.
2. Allow the engine to cool down completely.
3. Open the hood of your car.
4. Locate the water pump. It is located on the front of the engine, below the thermostat housing.
5. Disconnect the negative terminal of the battery.
6. Drain the coolant from the radiator.
7. Remove the serpentine belt.
8. Remove the bolts that hold the water pump in place.
9. Remove the old water pump and gasket.
10. Install the new water pump and gasket.
11. Tighten the bolts that hold the water pump in place.
12. Refill the radiator with coolant.
13. Reconnect the negative terminal of the battery.
14. Start the engine and allow it to run for a few minutes.
15. Check for leaks.
Tips:
* Be careful when draining the coolant. It is hot and can cause burns.
* Make sure to tighten the bolts that hold the water pump in place securely.
* If you are not comfortable performing this task, you can have it done by a qualified mechanic.
