1. Prepare your vehicle: Park your vehicle on a flat surface and turn off the engine. Engage the parking brake and chock the rear wheels to prevent your vehicle from rolling.
2. Locate the brake caliper: The brake caliper is the housing that holds the brake pads in place. It is located on the front wheel hub.
3. Remove the caliper: To remove the caliper, you will need to remove the two bolts that hold it in place. Use a socket wrench or a ratchet to loosen the bolts. Once the bolts are removed, you can lift off the caliper.
4. Remove the old brake pads: The brake pads are held in place by a metal clip. To remove the clip, use a flat-head screwdriver or a pair of pliers. Once the clip is removed, you can slide the old brake pads out of the caliper.
5. Inspect the caliper and rotor: Before installing new brake pads, it is important to inspect the caliper and rotor for damage or wear. If you notice any damage, such as cracks or excessive wear, you should replace the affected components.
6. Install the new brake pads: To install the new brake pads, simply slide them into the caliper. Make sure that the pads are seated properly and that the metal clip is securely in place.
7. Reinstall the caliper: Place the caliper back onto the wheel hub and secure it with the bolts. Tighten the bolts until they are snug.
8. Repeat steps 3-7 on the other side of your vehicle.
9. Test the brakes: Once you have installed the new brake pads, test the brakes by pressing the brake pedal several times. The brake pedal should feel firm and responsive.
Note: Changing brake pads can be a messy job. Make sure to wear gloves to protect your hands and cover the fenders of your vehicle to avoid any damage.
