- Philips Head Screwdriver
- Flat Head Screwdriver
- Replacement H1 High Beam bulb
- Replacement H7 Low Beam bulb
Instructions:
1. Open the Hood:
- Pull the hood release lever inside your vehicle.
- Go to the front of the vehicle and lift the hood.
2. Locate the Headlight Assembly:
- The headlight assembly is located behind the front bumper. You will see a black plastic housing with a clear lens cover.
3. Remove the Headlight Assembly:
- Use a Phillips head screwdriver to remove the two screws that secure the headlight assembly in place.
- Once the screws are removed, carefully pull the headlight assembly straight out from the vehicle.
4. Disconnect the Electrical Connector:
- There will be an electrical connector attached to the back of the headlight assembly.
- Press the release tab on the connector and disconnect it.
5. Remove the Old Headlight Bulb:
- Locate the old headlight bulb. It is held in place by a metal spring clip.
- Use a flat head screwdriver to pry the spring clip open.
- Remove the old headlight bulb from the socket.
6. Insert the New Headlight Bulb:
- Insert the new headlight bulb into the socket.
- Make sure the bulb is properly seated.
7. Secure the Spring Clip:
- Use the flat head screwdriver to pry the spring clip closed. This will secure the new headlight bulb in place.
8. Reconnect the Electrical Connector:
- Reconnect the electrical connector that you disconnected earlier.
9. Reinstall the Headlight Assembly:
- Carefully align the headlight assembly with the slots on the vehicle.
- Insert the two screws that you removed earlier and tighten them securely.
10. Close the Hood:
- Close the hood of the vehicle.
11. Test the Headlights:
- Turn on the headlights to make sure the new bulbs are working properly.
Repeat the process for the other headlight if needed.
