- Breaker bar
- Flat-head screwdriver
- Jack
- Jack stands
- Lug wrench
- Phillips-head screwdriver
- Pliers
- Socket set
- Torque wrench
Parts:
- Brake pads
- Brake rotors (if necessary)
1. Park the vehicle on a level surface and turn off the engine.
2. Loosen the lug nuts on the wheels that you will be working on, but do not remove them completely.
3. Jack up the vehicle and secure it with jack stands.
4. Remove the lug nuts and take off the wheels.
5. Locate the brake caliper. It is the metal housing that holds the brake pads in place.
6. Use a flat-head screwdriver to pry the caliper piston back into the caliper. This will create space for the new brake pads.
7. Remove the two bolts that hold the caliper in place.
8. Lift the caliper off the rotor.
9. Remove the old brake pads from the caliper.
10. Inspect the brake rotors for wear or damage. If they are worn or damaged, they will need to be replaced.
11. Install the new brake pads into the caliper.
12. Reinstall the caliper and tighten the bolts.
13. Pump the brake pedal several times to seat the new brake pads.
14. Reinstall the wheels and lug nuts.
15. Lower the vehicle and remove the jack stands.
16. Test the brakes by driving the vehicle slowly and applying the brakes.
Tips:
- If the brake fluid level is low, it will need to be topped off before you start this project.
- Be careful not to get brake fluid on your skin or in your eyes.
- If you have any questions about this project, consult a qualified mechanic.
