Auto >> AutoSPT >  >> Auto Repair

How do you reset computer on a 1999 suburban?

To reset the computer on a 1999 Suburban:

1. Turn the ignition key to the "Off" position.

2. Locate the "PCM" (Powertrain Control Module) fuse in the fuse box under the hood.

3. Remove the PCM fuse using the fuse puller tool provided in the fuse box cover.

4. Wait for at least 10 seconds.

5. Reinsert the PCM fuse.

6. Turn the ignition key to the "On" position, but do not start the engine.

7. Wait for approximately 30 seconds for the computer to reset.

8. Start the engine.

The computer should now be reset. If you are still experiencing problems, you may need to take your vehicle to a qualified mechanic for further diagnosis.

Auto Repair
Replacing a fusible link on 77 dodge 360 van does the part in plug just pull out? 5 Reasons Your Steering Wheel is Difficult to Turn
Car Care
Who bears the responsibility of making sure everyone is vehicle who must wear a seat belt IS wearing their belt? The 2022 Kia Telluride Is the Best SUV That’s Also the Worst Deal Right Now Are You Due For An Audi Repair & Maintenance Service?
Engine
How do you clear the check engine oil light in a 2000 GMC Sierra? Why would a 1983 Dodge Ram blow white smoke and the engine shake?
Electric Car
Can a drive shaft cause Toyota to shake? What are signs that the fuel filter is stopped up on 1996 Toyota Camry? How do I fix my 1999 Buick Park Avenue Ultra that blows cool air out the driver side when conditioner is on but HOT passenger no matter how you set temperature?
Autopilot
What is a industrial bowl with chopper? What makes motorbikes fast?
Car Photos
Why would the temperature gauge in a car go slightly cold while driving on freeway and revert to normal surface streets? Where does Ford come from? Where to find a diagram for the brake line system 1997 Chevy 3500 van?