- Jack and jack stands
- Lug wrench
- Socket wrench
- Allen key
- Flathead screwdriver
- Wire brush
- Brake cleaner
- New brake pads
- Brake grease
Instructions:
1. Park the car in a safe location, and engage the parking brake. Turn off the engine, and allow it to cool down completely.
2. Chock the rear wheels to prevent the car from rolling.
3. Jack up the front of the car and place it on jack stands. Make sure the car is stable before proceeding.
4. Remove the lug nuts and take off the wheel.
5. Locate the two bolts that hold the caliper in place. They are located on the back of the caliper. Use an allen key to loosen the bolts.
6. Once the bolts are loose, pry the caliper off of the rotor. Be careful not to damage the rotor.
7. Remove the old brake pads from the caliper. There will be two pads, one on each side of the rotor.
8. Clean the caliper and rotor with a wire brush. This will remove any dirt or debris that could interfere with the new brake pads.
9. Apply a thin layer of brake grease to the back of the new brake pads. This will help to reduce noise and prevent the pads from sticking to the caliper.
10. Slide the new brake pads into the caliper. Make sure that the pads are seated properly.
11. Reinstall the caliper and tighten the bolts.
12. Replace the wheel and lug nuts.
13. Lower the car off the jack stands.
14. Test the brakes before driving the car. Pump the brake pedal several times to make sure that the brakes are working properly.
Tips:
- If the brake pads are very worn, you may need to replace the brake rotors as well.
- You should also inspect the brake fluid level and add fluid if necessary.
- If you are not comfortable performing this task, you can take your car to a mechanic to have the brake pads replaced.
