Auto >> AutoSPT >  >> Auto Repair

How to reset service indicator message for 2000 Mercedes Benz E320 after A or B is completed?

To reset the service indicator message for a 2000 Mercedes Benz E320 after an A or B service has been completed, here are the steps:

1. Turn the ignition key to the "On" position without starting the engine.

2. Press and hold the "OK" button on the instrument cluster.

3. While holding the "OK" button, turn the ignition key to the "Start" position.

4. Continue to hold the "OK" button for approximately 10 seconds until the service indicator message disappears.

5. Release the "OK" button.

The service indicator message should now be reset, indicating that the A or B service has been completed.

Note: If the service indicator message does not reset, it is possible that there is a problem with the vehicle's electronic systems, and you may need to have it diagnosed by a professional mechanic.

Auto Repair
Where can you find BSA motorcycles and parts for sale worldwide? What tools needed to remove a starter motor?
Car Care
You cannot make your car payements Can you turn in? Catalytic Converter Thieves Target These 5 Vehicles the Most What does it mean the phrase When life gives you lemons become a shady used car dealer?
Engine
What cc is a 95 horse power? What is the Temperature of a car engine when running?
Electric Car
What are the pros and cons of gas vs. electric hedge trimmer models? Interior and hazard lights flashing 1994 Chevy silverado just after start up then they go off there is also an audible clicking from under the dash on drivers side? Where do you install the crank position sensor in a 1996 e350 ford bus?
Autopilot
Timing marks for 90cc Chinese ATV? Where motorcycle race track somerset?
Car Photos
How do you put your 2000 Honda Passport into 4 Wheel Drive? Coolant temp sensor location on 2001 ford ranger 2.3l? What does the check engine light on a Nissan Pathfinder mean?