[Image of a wiring diagram for a 300 Bayou 4 wheeler]
This diagram shows the electrical components of the 300 Bayou 4 wheeler and how they are connected to the battery. The battery is located under the seat of the wheeler. The positive terminal of the battery is connected to the red wire, which runs to the starter solenoid. The negative terminal of the battery is connected to the black wire, which runs to the frame of the wheeler.
The starter solenoid is a relay that is used to engage the starter motor. When the ignition key is turned on, the positive terminal of the battery is connected to the red wire, which runs to the starter solenoid. The starter solenoid then engages the starter motor, which starts the engine.
The alternator is a generator that is used to charge the battery. When the engine is running, the alternator produces an electrical current that is used to charge the battery. The alternator is connected to the battery by the red and black wires.
The voltage regulator is a device that is used to control the voltage of the electrical system. The voltage regulator is connected to the battery by the red and black wires.
The main fuse is a fuse that is used to protect the electrical system from damage. The main fuse is located under the seat of the wheeler. It is a 30 amp fuse.
The ignition switch is a switch that is used to turn on the ignition. The ignition switch is located on the handlebars of the wheeler.
The kill switch is a switch that is used to turn off the engine. The kill switch is located on the handlebars of the wheeler.
The fuel gauge is a gauge that is used to measure the amount of fuel in the fuel tank. The fuel gauge is located on the handlebars of the wheeler.
The tachometer is a gauge that is used to measure the engine speed in RPMs. The tachometer is located on the handlebars of the wheeler.
