- Replacement turn signals
- Socket set
- Phillips-head screwdriver
- Flat-head screwdriver
- Pliers
Instructions:
1. Park your vehicle on a level surface and turn off the engine. If the turn signal requires an incandescent lightbulb and not an LED, allow it to cool down completely.
2. Open the hood of your vehicle and locate the turn signal assembly. It is usually located near the front of the vehicle, on either side of the headlights.
3. Remove the screws or bolts that hold the turn signal assembly in place. There may be one or two screws or bolts on the top and/or bottom of the assembly.
4. Disconnect the electrical connector from the turn signal assembly. The electrical connector is usually a small, plastic plug that connects the turn signal assembly to the vehicle's electrical system.
5. Remove the turn signal assembly from the vehicle. Once you have disconnected the electrical connector, you should be able to remove the turn signal assembly by pulling it straight out of the vehicle.
6. Install the new turn signal assembly. To install the new turn signal assembly, simply insert it into the vehicle and reconnect the electrical connector. Make sure that the new turn signal assembly is securely seated in place.
7. Replace the screws or bolts that you removed in step 3.
8. Close the hood of your vehicle.
.Test the turn signals to make sure that they are working properly. Turn on the hazard lights and check to make sure that all four turn signals are flashing. If one or more of the turn signals is not working, you may need to replace the turn signal bulb or the turn signal switch.
