1. Park your vehicle on a level surface. Turn off the engine and allow it to cool down. Engage the parking brake.
2. Locate the transmission fluid drain plug. It is located on the bottom of the transmission housing, towards the rear of the vehicle. It is a 17mm hex-head bolt.
3. Place an oil drain pan under the drain plug. Make sure the pan is large enough to catch all of the fluid that will drain out.
4. Loosen the drain plug. Use a 17mm wrench to loosen the drain plug until it is finger-tight.
5. Allow the transmission fluid to drain. This may take a few minutes.
6. Replace the drain plug. Tighten the drain plug until it is snug.
7. Locate the transmission fluid fill plug. It is located on the top of the transmission housing, towards the front of the vehicle. It is an 18mm hex-head bolt.
8. Remove the fill plug. Use an 18mm wrench to loosen the fill plug until it is finger-tight.
9. Insert the fluid pump into the fill hole. The fluid pump should have a capacity of at least 1 liter.
10. Pump new transmission fluid into the transmission housing. Continue pumping until the fluid level reaches the "Full" mark on the fluid dipstick.
11. Replace the fill plug. Tighten the fill plug until it is snug.
12. Start the engine and allow it to warm up. This will circulate the new transmission fluid throughout the system.
13. Check the transmission fluid level. Use the fluid dipstick to check the fluid level. Add more fluid if necessary.
14. Take your vehicle for a short test drive. This will help to distribute the new fluid throughout the system.
