Tools and Materials Needed:
- Phillips head screwdriver
- Flat head screwdriver
- Replacement wing mirror assembly
Instructions:
1. Remove the Interior Door Panel:
- Use a Phillips head screwdriver to remove the screws that secure the interior door panel to the door.
- Gently pry off the door panel using a flat head screwdriver, starting from one corner and working your way around.
- Disconnect any electrical connectors that may be attached to the door panel.
2. Locate the Three Mounting Bolts:
- Once the door panel is removed, you will see the wing mirror assembly attached to the door with three mounting bolts.
3. Remove the Mounting Bolts:
- Use a Phillips head screwdriver to loosen and remove the three mounting bolts.
4. Disconnect the Electrical Connector (if Applicable):
- If the wing mirror has an electrical connector, carefully disconnect it.
5. Remove the Old Wing Mirror:
- Once the mounting bolts are removed and the electrical connector is disconnected, you can gently pull the old wing mirror assembly out of its housing.
6. Install the Replacement Wing Mirror:
- Align the replacement wing mirror with its housing and insert it into place.
- Secure it using the three mounting bolts.
7. Reconnect the Electrical Connector (if Applicable):
- If there is an electrical connector, reconnect it.
8. Reattach the Interior Door Panel:
- Reattach the interior door panel by aligning it with the door and reinstalling the screws you removed earlier.
Test the new wing mirror to ensure that it is properly secured and adjusting.
Note:
- The steps mentioned may vary slightly for different models of the Fiat Panda.
- It is essential to follow the specific instructions provided in your vehicle's repair manual or by the vehicle manufacturer to avoid any complications or damage during the process.
