The thermostat is located on the front end of the engine. It is situated in a small housing that connects the upper and lower radiator hoses.
The thermostat is held in place by two bolts and a gasket.
Here are some additional details about the thermostat location on the 2006 Chevrolet Impala V6-3.5 liter engine:
* The thermostat is located on the driver's side of the engine.
* It is near the top of the engine, just below the water pump.
* The thermostat housing is made of black plastic.
* To access the thermostat, you will need to remove the upper radiator hose.
Here are some tips for replacing the thermostat on a 2006 Chevrolet Impala V6-3.5 liter engine:
* Make sure that the engine is cool before starting work.
* Disconnect the negative battery terminal to avoid any electrical problems.
* Drain the coolant from the radiator.
* Remove the upper radiator hose.
* Remove the two bolts that hold the thermostat housing in place.
* Remove the old thermostat and gasket.
* Install a new thermostat and gasket.
* Tighten the bolts and replace the upper radiator hose.
* Refill the coolant system.
* Start the engine and check for leaks.
