1. Battery and Ground Connections:
- Connect the positive (+) terminal of the battery to the starter solenoid.
- Connect the negative (-) terminal of the battery to the chassis ground.
- Ensure all ground connections are clean and secure.
2. Ignition Switch:
- Connect the "BAT" terminal on the ignition switch to the positive (+) terminal of the battery.
- Connect the "IGN" terminal to the coil positive (+) terminal.
- Connect the "ACC" terminal to the power supply for accessories like the radio or wipers.
3. Starter Solenoid:
- Connect the large terminal on the starter solenoid to the positive (+) battery terminal.
- Connect the small terminal to the "S" terminal on the ignition switch.
4. Distributor:
- Connect the coil wire from the coil negative (-) terminal to the center of the distributor cap.
- Connect the distributor wires from the distributor cap to the corresponding spark plugs in the correct firing order.
5. Manual Choke:
- Locate the manual choke on the carburetor.
- Connect one end of the choke cable to the choke lever on the carburetor.
- Connect the other end of the choke cable to the choke control knob inside the car.
6. Headlights:
- Connect the positive (+) terminal of the headlight switch to the positive (+) battery terminal.
- Connect the negative (-) terminal of the headlight switch to the ground.
- Connect the headlight switch to the headlight bulbs using the appropriate wiring harness.
7. Taillights and Brake Lights:
- Connect the positive (+) terminal of the taillight/brake light switch to the positive (+) battery terminal.
- Connect the negative (-) terminal of the switch to the ground.
- Connect the switch to the taillights and brake lights using the appropriate wiring harness.
8. Turn Signals:
- Connect the positive (+) terminal of the turn signal switch to the positive (+) battery terminal.
- Connect the negative (-) terminal of the switch to the ground.
- Connect the turn signal switch to the turn signal bulbs using the appropriate wiring harness.
9. Fuel Pump:
- Connect the positive (+) terminal of the fuel pump to the positive (+) battery terminal.
- Connect the negative (-) terminal of the fuel pump to the ground.
10. Voltage Regulator:
- Connect the "BAT" terminal on the voltage regulator to the positive (+) battery terminal.
- Connect the "FLD" terminal to the field terminal on the alternator.
- Connect the "IGN" terminal to a switched power source, such as the ignition switch.
11. Check and Test:
- Double-check all connections to ensure they are secure and properly connected.
- Test the electrical components by turning on the ignition switch and checking for power at the various components.
- If everything seems to be working correctly, start the engine and verify that all electrical systems are functioning as expected.
Note: It's essential to follow a detailed wiring diagram specific to your Chevy Camaro model and year for precise instructions. This guide provides a general overview, and professional assistance is recommended if you're not confident in performing electrical work on your vehicle.
