The A/C clutch on a 2000 Ford Taurus is located on the front of the engine, just below the power steering pump. It is a circular, metal component with a single electrical connector. To replace the A/C clutch, you will need the following tools:
* Socket wrench set
* Torque wrench
* Screwdriver
* Pry bar
* New A/C clutch
Instructions:
1. Disconnect the negative battery terminal.
2. Remove the serpentine belt.
3. Remove the four bolts that hold the A/C compressor to the engine block.
4. Carefully pry the A/C compressor off of the engine block.
5. Disconnect the electrical connector from the A/C clutch.
6. Remove the A/C clutch from the compressor.
7. Inspect the A/C clutch for wear or damage. If the clutch is damaged, replace it with a new one.
8. Reinstall the A/C clutch onto the compressor.
9. Reconnect the electrical connector to the A/C clutch.
10. Reinstall the A/C compressor onto the engine block.
11. Replace the four bolts that hold the A/C compressor to the engine block.
12. Reinstall the serpentine belt.
13. Reconnect the negative battery terminal.
14. Test the A/C system to make sure that it is working properly.
Tips:
* It is important to disconnect the negative battery terminal before beginning this repair to avoid any electrical accidents.
* Be careful not to damage the A/C compressor when removing it from the engine block.
* Inspect the A/C clutch for wear or damage before reinstalling it. If the clutch is damaged, replace it with a new one.
* Tighten the bolts that hold the A/C compressor to the engine block to the specified torque.
