1. Park your Baja in a safe location and turn off the engine.
2. Open the trunk of your Baja.
3. Locate the rear turn signal assembly. It is located in the rear of the vehicle, on the side where the bulb needs to be replaced.
4. Remove the two screws that hold the rear turn signal assembly in place.
5. Once the screws are removed, gently pry the rear turn signal assembly out of its housing.
6. Remove the old turn signal bulb by turning it counterclockwise.
7. Replace the old turn signal bulb with a new one.
8. Reinsert the rear turn signal assembly into its housing and secure it with the two screws that were removed earlier.
9. Test the new turn signal bulb to ensure that it is working properly.
10. Close the trunk of your Baja and you're done!
Here are some additional tips for changing a rear turn signal bulb on a Subaru Baja:
* If you have difficulty removing the old turn signal bulb, you can use a pair of pliers to help you.
* Be careful not to drop the old turn signal bulb. If it breaks, you will need to clean up the glass shards.
* Make sure that the new turn signal bulb is properly seated in the socket before you reinsert the rear turn signal assembly.
* Test the new turn signal bulb before you close the trunk of your Baja.
