Tools and Materials Needed:
1. New Flasher Relay
2. Screwdriver
3. 10mm Wrench
Instructions:
1. Locate the Flasher Relay:
- Open the hood of your 1964 Impala.
- The flasher relay is typically located in the engine compartment, mounted near the firewall. It's a small, black cylindrical or rectangular-shaped device.
2. Disconnect the Battery:
- As a safety precaution, disconnect the negative battery terminal to avoid any electrical accidents during the repair.
3. Remove the Old Flasher:
- Use the screwdriver to gently pry open the locking tab on the flasher relay.
- Once the tab is released, pull the old flasher relay straight out of its housing.
4. Install the New Flasher:
- Align the new flasher relay with the housing.
- Push it firmly into place, ensuring the locking tab snaps back into position.
5. Reconnect the Battery:
- Reattach the negative battery terminal.
6. Test the Turn Signals:
- Turn the ignition switch to "ON" but do not start the engine.
- Engage the turn signal lever. Verify that the turn signal indicators on the dashboard and the lights on the respective side of the vehicle are working properly.
7. Close the Hood:
- If the turn signals are functioning correctly, close the hood of your Impala.
