Auto >> AutoSPT >  >> Engine

What are the Torque settings for big ends and mains on Ford Fiesta 1.4 2007 FXJA engine?

Connecting rods (big ends):

- Before tightening, apply engine oil to the threads of the bolts and to the bearing shells.

- Tighten connecting rod bolts in two steps:

- First step: 20 Nm

- Second step: Tighten an additional 90 degrees

Main bearings (mains):

- Before tightening, apply engine oil to the threads of the bolts and to the bearing shells.

- Tighten main bearing bolts in three steps:

- First step: 25 Nm

- Second step: 65 Nm

- Third step: Tighten an additional 90 degrees

Auto Repair
Dodge ram rear door latch assembly replacement get open? Glow Plug in a Car – What Is It and How It Works
Car Care
When Should You Change Your Wiper Blades? Does State Farm Insurance use the NADA blue book to establish worth for vehicles? How to Cancel Mister Car Wash Subscription with 5 Easy Ways
Engine
Eb falcon 1993 fuel gauge shows full then drops to empty and wont work? Why do the high beams work but low on your 2003 Nissan Xterra?
Electric Car
Will a 2003 Buick regal 3.8 engine fit 2000 SS Monte Carlo? Where could someone purchase a 1957 Corvette? What happens when your car battery light comes on and the thermostat hand goes up?
Autopilot
How do you change the color in autocad? How do you sort out the timing on a Vauxhall Astra 1.7 tdi?
Car Photos
Does the number plate of a car represent when it was made? How do you change the rear bumper on a 91 Chevy Lumina Euro 2 door? Will 265x70x16 tires fit on a stock 2012 Jeep Wrangler Sport?