- Phillips head screwdriver
- Flat head screwdriver
- Socket set
- Extension
- Wrench
1. Start by removing the rear seat cushion by pulling up on the front edge and then lifting it out.
2. Once the seat cushion is removed, you will see a black plastic cover held in place by four Phillips head screws. Remove these screws and then lift the cover off.
3. Under the cover, you will see the fuel pump assembly. It is held in place by a 10mm bolt and a fuel line.
4. Use the socket set and extension to remove the 10mm bolt.
5. Use the flat head screwdriver to pry up the fuel line connector and then disconnect the fuel line.
6. Once the bolt is removed and the fuel line is disconnected, you can lift the fuel pump assembly out of the tank.
Be careful not to spill any fuel when removing the fuel pump.
