1. Open the front door and remove the three T30 Torx screws that hold the front door panel in place. Two of the screws are located in the door handle recess, and the third is located at the bottom of the door panel, behind the door release handle.
2. Remove the trim ring around the door latch using a flat-head screwdriver.
3. Remove the two screws that hold the window winder handle in place, and remove the handle.
4. Disconnect the electrical connector for the window switch and the door lock switch by pressing down on the locking tab and pulling the connector apart.
5. Remove the T25 Torx screw that holds the speaker in place, and remove the speaker.
6. Carefully pry up the front door panel, starting at the bottom corner. There are plastic clips that hold the panel in place, so be careful not to break them.
7. Once the front door panel is removed, you can remove the vapor barrier by peeling it off of the door frame. Be careful not to tear it.
To reinstall the front door panel and vapor barrier, simply follow the steps in reverse order.
