2. Disconnect the battery. This is a safety precaution to prevent the engine from accidentally starting while you are working on it. Disconnect the negative battery terminal first, and then the positive terminal.
3. Remove the starter mounting bolts. There are two bolts that hold the starter in place. Use a wrench to loosen and remove these bolts.
4. Remove the starter solenoid wires. There are two wires that connect the starter solenoid to the battery. Disconnect these wires by pulling them off of the solenoid terminals.
5. Remove the starter from the engine. Once the mounting bolts and solenoid wires have been removed, you can remove the starter from the engine. Gently pry it out of its mounting location and set it aside.
6. Inspect the starter. Once the starter is removed, inspect it for damage. Look for any cracks or damage to the housing, and check the condition of the brushes and commutator. If the starter is damaged, it will need to be replaced.
7. Reinstall the starter. If the starter is in good condition, you can reinstall it. To do this, simply reverse the steps you took to remove it. Be sure to tighten the mounting bolts and solenoid wires securely.
8. Reconnect the battery. Once the starter is reinstalled, you can reconnect the battery. Connect the positive terminal first, and then the negative terminal.
9. Test the starter. Once the battery is reconnected, you can test the starter. Turn the key to the "Start" position and listen for the starter to engage. If the starter engages, the engine will start.
