1. Gather the following materials:
- New coolant (refer to your owner's manual for the recommended type and amount)
- Funnel
- 5mm Allen wrench
- Bucket or pan for catching the old coolant
- Hose or tubing for draining the coolant
2. Prepare the brute force 650:
- Remove the seat.
- Place a bucket or pan underneath the radiator to catch the old coolant.
3. Drain the old coolant:
- Locate the drain plug on the bottom of the radiator.
- Use the 5mm Allen wrench to loosen the drain plug.
- Allow the old coolant to drain completely into the bucket or pan.
4. Flush the cooling system (Optional):
- To ensure a complete removal of old coolant and any dirt or debris, you can flush the system with water or a flushing agent.
- Attach a hose or tubing to the radiator drain plug.
- Open the radiator cap.
- Run water or the flushing agent through the system until clear liquid comes out.
- Close the drain plug and the radiator cap.
5. Refill the cooling system:
- Remove the radiator cap.
- Use the funnel to add new coolant to the radiator.
- Fill the radiator to the specified level indicated in the owner's manual.
6. Check for leaks:
- Start the engine and let it run for a few minutes.
- Check the radiator and surrounding area for any coolant leaks.
- If you notice any leaks, turn off the engine and retighten the drain and /or radiator cap until the leak stops.
7. Adjust the coolant level:
- Once the engine has cooled down, recheck the coolant level in the radiator.
- Add more coolant if necessary to bring it to the specified level.
8. Replace the seat and any other parts you removed during the process.
Note: Always refer to the owner's manual for specific instructions and precautions for your Brute Force 650 model. Coolant can be toxic, so be sure to dispose of it properly and avoid contact with skin or eyes.
