- Socket Set
- Ratchet
- Extension Bar
- Torque Wrench
- Flat Head Screwdriver
Step-by-Step guide
1. Disconnect the battery
2. Locate the alternator
- The alternator is located on the front of the engine, just below the water pump.
3. Remove the alternator belt
- To remove the alternator belt, you will need to loosen the bolt or tensioner pulley. Once the belt is loose, you can remove it from the alternator pulley.
4. Remove the alternator bolts
- There are three bolts that hold the alternator in place. You can remove these bolts with the socket set and ratchet.
5. Remove the alternator
- Once the bolts are removed, you can pull the alternator out of the engine compartment.
6. Install the new alternator
- Insert the new alternator into the engine compartment and secure it with the three bolts.
7. Install the alternator belt
- Replace the alternator belt and tighten the bolt or tensioner pulley.
8. Reconnect the battery
9. Start the engine and check the alternator
- Start the engine and check the voltage at the battery. It should be between 13 and 14 volts.
