Auto >> AutoSPT >  >> Auto Repair

How do you change a water pump seal on 1998 suzuki rm125 dirt bike?

1. Drain the coolant. Locate the drain bolt on the bottom of the water pump cover and remove it. Allow all of the coolant to drain out.

2. Remove the water pump cover. Use a socket wrench to remove the bolts holding the water pump cover in place.

3. Remove the old water pump seal. Pry the old water pump seal out of the cover using a pry bar or screwdriver. Be careful not to damage the cover.

4. Clean the water pump cover. Use a degreaser and a brush to clean the water pump cover. Make sure that all of the old gasket material is removed.

5. Install the new water pump seal. Press the new water pump seal into the cover. Make sure that it is seated properly.

6. Replace the water pump cover. Install the water pump cover and bolts and reconnect the coolant line to the water pump cover.

7. Reinstall coolant Refill the cooling system with the correct mixture of coolant and water.

8. Start the engine and check for leaks. Start the engine and let it run for a few minutes. Check for leaks around the water pump cover.

Auto Repair
Where to install seat belts in the back on a 1965 Impala? How much to fix motor mount on 2000 buick lesabre?
Car Care
What does it mean when your car go in gear? A Definitive Guide To Test Your Car Battery With A Digital Multimeter How to Stop Windshield Wipers from Squeaking? 5 Ways to Try!
Engine
When does the engine on a 2001 BMW 325i fail? What kind of antifreeze goes in a 1996 Ford Ranger with 2.3 engine?
Electric Car
Where is iac on 1994 Chevy S-10 pickup? Where is the oil filter located on a 2002 Nissan frontier? What affects does a non-working smog-air pump have on vehicle?
Autopilot
Day 15 Capability: Navigate city roads at night Harley 2004 flhtcui starter relay location?
Car Photos
Where is the windshield washer in Nissan Quest? How do you read the trouble codes on a 2004 Chrysler Sebring Convertible? Why Car shakes when stopped on brakes?