1. Gather Necessary Tools:
- Phillips Head Screwdriver
- Flat Head Screwdriver
- 10mm Socket Wrench
- 7mm Socket Wrench
- 13mm Socket Wrench
- Replacement Side Mirror (with mounting hardware if necessary)
2. Prepare the Replacement Mirror:
- Open the packaging of the replacement side mirror and inspect the contents. Make sure you have all the necessary components, including the mirror glass, housing, and mounting hardware (if applicable). Set the replacement mirror aside.
3. Remove the Existing Mirror Glass:
- Use a Phillips head screwdriver to remove the two screws on the back of the existing side mirror.
- Gently pry the mirror glass away from the housing, taking care not to damage the surroundings.
4. Disconnect the Mirror Connector:
- Locate the wiring harness connected to the back of the existing side mirror.
- Use a flathead screwdriver to release the lock tab on the electrical connector and carefully detach the connector from the side mirror housing.
5. Remove the Side Mirror Housing:
- Use a 7mm socket wrench to remove the two bolts that secure the mirror housing to the vehicle's door.
- While supporting the housing with one hand, use a flathead screwdriver to gently pry the housing off of the door panel.
6. Remove the Mounting Plate (If Necessary):
- Some Jeep Grand Cherokee models have a mounting plate between the mirror housing and the door panel. If present, use a 10mm socket wrench to remove the plate.
7. Install the Mounting Plate (If Necessary):
- If you removed a mounting plate in the previous step, position the new one over the door panel and secure it using the bolts you removed earlier.
8. Install the Replacement Side Mirror Housing:
- Position the replacement side mirror housing over the mounting plate or directly onto the door panel, depending on your vehicle's setup.
- Secure the housing using the bolts you removed earlier.
9. Connect the Mirror Connector:
- Reconnect the electrical connector by aligning it with the mating connector on the back of the replacement mirror. Press the connectors together until they snap in place.
10. Install the Replacement Mirror Glass:
- Place the replacement mirror glass onto the housing and secure it using the screws you removed earlier.
- Verify that the mirror is positioned correctly and properly secured.
11. Test the New Side Mirror:
- Adjust the new side mirror to your preferred viewing angle.
- Test the mirror's adjustment mechanisms, including up/down, left/right, and manual/electric adjustments, if equipped.
12. Clean Up:
- Clean up any debris or tools used during the replacement process.
Congratulations, you have successfully replaced the side mirror on your 1998 Jeep Grand Cherokee Limited. Ensure that the mirror is properly secured, adjusted, and functioning correctly before driving.
