The Malfunction Indicator Light (MIL), also known as the "Check Engine" light, is designed to alert drivers of potential problems with their vehicle's engine or emission control system. In most cases, the MIL can be reset by following a few simple steps:
1. Turn the ignition to the "ON" position. Do not start the engine.
2. Locate the "MIL" or "Check Engine" light. It is typically located on the dashboard.
3. Press and hold the "MIL" or "Check Engine" light for approximately 10 seconds. The light should begin to flash.
4. Continue holding the "MIL" or "Check Engine" light until it turns off. This may take up to 30 seconds.
5. Start the engine. The MIL should no longer be illuminated.
If the MIL remains illuminated after following these steps, it is recommended that you take your vehicle to a qualified mechanic or dealership for further diagnosis and repair.
Note: The MIL is not a substitute for regular maintenance and inspections. It is important to have your vehicle serviced according to the manufacturer's recommendations to prevent potential problems.
