_Tools:_
-Jack and jack stands
-Socket set
-Ratchet
-Extension bar
-Flat head screwdriver
-Phillips head screwdriver
-Pliers
_REMOVAL:_
_1:_ Park the vehicle on a level surface and engage the parking brake.
_2:_ Use the jack and jack stands to raise the front of the vehicle. Refer to your vehicle's owner's manual for the proper jacking points.
_3:_ Remove the front wheels.
_4:_ Remove the plastic fender liner by prying it out of the wheel well with a flat head screwdriver.
_5:_ Locate the bolts that secure the front fender to the vehicle body. There will be two bolts at the top of the fender and two at the bottom.
_6:_ Use the ratchet, socket and extension bar to remove the bolts.
_7:_ Disconnect the electrical connector for the turn signal light.
_8:_ Carefully lift the front fender off of the vehicle.
_INSTALLATION:_
_1:_ Position the front fender on the vehicle.
_2:_ Start the bolts by hand and then tighten them with the ratchet, socket and extension bar.
_3:_ Reconnect the electrical connector for the turn signal light.
_4:_ Reinstall the plastic fender liner.
_5:_ Reinstall the front wheels.
_6:_ Lower the vehicle from the jack stands
