* Carburetor cleaner
* Small screwdriver or allen wrench
* Socket set
* Cleaning rag
* Safety glasses
Step 2: Prepare the carburetor.
1. Turn off the fuel supply to the carburetor.
2. Disconnect the throttle and choke cables from the carburetor.
3. Remove the air filter from the carburetor.
4. Remove the float bowl drain plug and drain the float bowl.
Step 3: Clean the exterior of the carburetor.
1. Spray the carburetor with carburetor cleaner and let it sit for a few minutes.
2. Use a cleaning rag to wipe away any dirt or debris.
Step 4: Remove the carburetor jets.
1. Use a small screwdriver or allen wrench to remove the pilot jet, main jet, and needle jet.
2. Inspect the jets for any dirt or debris and clean them if necessary.
Step 5: Clean the carburetor passages.
1. Spray carburetor cleaner into the carburetor passages and let it sit for a few minutes.
2. Use a cleaning rag to wipe away any dirt or debris.
Step 6: Reinstall the jets and float bowl drain plug.
1. Reinstall the jets into the carburetor.
2. Tighten the jets until they are snug.
3. Reinstall the float bowl drain plug.
Step 7: Reconnect the throttle and choke cables.
1. Reconnect the throttle and choke cables to the carburetor.
2. Adjust the cables so that they have the proper amount of slack.
Step 8: Reinstall the air filter.
1. Reinstall the air filter onto the carburetor.
2. Tighten the air filter until it is snug.
Step 9: Test the carburetor.
1. Turn on the fuel supply to the carburetor.
2. Start the engine and let it run for a few minutes.
3. Check for any leaks or other problems.
If the carburetor is working properly, you should be able to ride your motorized bike without any problems.
