1. Gather the necessary tools and materials:
- Wrench set
- Screwdriver
- Container to catch the old brake fluid
- New brake fluid (DOT 3 or 4)
- Funnel
2. Locate the clutch master cylinder. It is typically mounted on the handlebar or near the clutch lever.
3. Remove the cover from the clutch master cylinder.
4. Use a screwdriver to loosen the bleed screw located on the bottom/side of the clutch master cylinder.
5. Attach a clear hose to the bleed screw and place the other end of the hose into the container to catch the old brake fluid.
6. Have a helper slowly squeeze the clutch lever with firm, even pressure.
7. As they hold the lever, you open the bleed screw. Do this only until you see the stream of bubbles stop.
8. Close the bleed screw and have your helper release the clutch lever.
9. Repeat steps 6-8 until no more air bubbles are visible in the fluid.
10. Top up the clutch master cylinder with new brake fluid.
11. Replace the master cylinder cover.
12. Test the clutch by pulling the lever. It should feel firm and engage smoothly.
Remember to take breaks when bleeding the clutch to prevent overheating the system. Also, ensure to top up the clutch fluid reservoir after bleeding to maintain the proper fluid level.
