* Wrenches
* Socket set
* Screwdrivers
* Jack
* Jack stands
Instructions:
1. Park the bus on a level surface and turn off the engine.
2. Jack up the front of the bus and place the jack stands underneath the frame.
3. Remove the transmission inspection cover from the bottom of the transmission.
4. Use the wrench to loosen the locknut on the clutch release arm.
5. Use the screwdriver to turn the adjuster screw until the clutch arm moves about 1/8 inch (3 mm) when you press it with your finger.
6. Tighten the lock nut.
7. Remove the jack stands and lower the bus.
8. Test drive the bus to ensure the clutch is adjusted correctly.
Additional Tips:
* If the clutch is slipping, you may need to adjust the clutch cable.
* If the clutch is not disengaging properly, you may need to replace the clutch release bearing.
* It is important to make sure that the clutch is adjusted correctly in order to prevent damage to the transmission.
