Auto >> AutoSPT >  >> Auto Repair

How do you reset the code after replacing 2004 BMW 525i solenoid vanos unit?

To reset the code after replacing the 2004 BMW 525i solenoid vanos unit, you will need to:

1. Disconnect the battery for at least 15 minutes.

2. Reconnect the battery.

3. Turn on the ignition, but do not start the engine.

4. Wait for the engine to fully power up.

5. Turn off the ignition.

6. Wait for 1 minute.

7. Start the engine.

8. The code should now be reset.

If the code is not reset, you may need to take your car to a mechanic to have it reset with a diagnostic tool.

Auto Repair
How do you reset the check engine light on a 2004 Ford Freestar? How do you program a 2006 Chrysler Sebring key fob?
Car Care
5 Reasons Your Vehicle May Not Drive Smoothly How much does a Tire Weigh 5 Surefire Ways to Protect Your Car in Rainy Days
Engine
What size tires did 1999 Ford Ranger XL come with from the factory? Where do you found the fuel pump fuse on 86 Toyota MR2?
Electric Car
Does a Chevy 2000 S 10 have injectors or throttle body? How much does a Chevy 454 short block weigh? Where is the egr valve located on a 1995 Nissan maxima?
Autopilot
How to set the timing marks on cam and crank? How do you make a 99 civic lx faster on first gear?
Car Photos
Where is the paint code for 1991 Chevrolet Camaro? Where are the hidden vin locations for a 1972 ford mustang? Car scratches how to get them out?