Parts Needed:
- Signal light glass cover (replacement).
- Masking tape.
- Screwdriver.
- Pry tool (optional).
1. Preparatory Steps:
- Ensure that the vehicle is properly parked and the engine is turned off.
- If necessary, clean the area around the broken signal light cover to make the repair easier.
- For safety reasons, wear protective gloves to avoid cuts from any glass fragments.
2. Remove the Old Cover:
- Gently remove any loose glass fragments from the broken cover.
- Use masking tape to cover any exposed sharp edges to prevent injury during the repair process.
- Locate the retention screws or clips that hold the signal light cover in place. These are usually located around the edges of the cover.
- Use a screwdriver or pry tool to carefully release the retention screws or clips. Be careful not to damage any surrounding parts.
- Once all the retention screws or clips are released, gently remove the broken glass cover from its housing.
3. Clean the Housing:
- Thoroughly clean the signal light housing to remove any debris or glass fragments that may be present.
- Ensure the housing is free from dirt, dust, or moisture.
4. Install the New Cover:
- Place the replacement glass cover carefully over the signal light housing, ensuring it aligns correctly.
- Secure the new glass cover by tightening the retention screws or clipping it into place.
- Double-check that the glass cover is properly and firmly attached.
5. Test the Signal Light:
- Turn on the signal lights to ensure they function properly and the new cover is securely in place.
Please note that specific models and years of the Volvo 960 may have slight variations in the steps involved. If you feel uncertain or uncomfortable with any step, it's advisable to consult the vehicle's owner's manual or seek assistance from a professional mechanic.
