Error Code 6:
* Description: Hydraulic Pressure Sensor
* Cause: The hydraulic pressure sensor is not sending a signal to the controller, or the signal is out of range.
* Solution: Check the hydraulic fluid level and condition. If the fluid is low or contaminated, it may need to be replaced. Inspect the hydraulic lines and fittings for leaks or restrictions. If any leaks or restrictions are found, they should be repaired or replaced. Finally, check the hydraulic pressure sensor and replace it if necessary.
Error Code 5:
* Description: Lift Cylinder Position Sensor
* Cause: The lift cylinder position sensor is not functioning properly.
* Solution: Inspect the lift cylinder position sensor and make sure it is securely mounted. Check the wiring and connections to the sensor. If the wiring is damaged or loose, it should be repaired or replaced. Finally, check the sensor itself for damage or malfunction and replace if necessary.
It is recommended to refer to the specific service manual for your Raymond forklift model for detailed troubleshooting steps and procedures. If the problem persists or you are unsure of the repairs required, it is always best to contact an authorized Raymond forklift service technician.
