Here is a general outline of the steps involved in bypassing an immobilizer on a Movano van, but please keep in mind that the specific process may vary depending on the exact make and model of your vehicle:
Locate the immobilizer control unit (ICU):
The ICU is usually located under the dashboard or near the steering column.
Disconnect the ICU power supply:
Locate the power supply wires to the ICU and disconnect them. This will prevent the immobilizer system from receiving power and deactivating the vehicle.
Install a bypass module:
Connect a bypass module to the wiring harness of the immobilizer system. The bypass module will act as a bridge between the immobilizer and the vehicle's ignition system, allowing the vehicle to start without the need for the immobilizer key.
Test the bypass:
Start the vehicle to make sure that the immobilizer bypass has been successful. The vehicle should start normally without requiring the immobilizer key.
Again, it is important to emphasize that bypassing the immobilizer system can have security implications, and it should only be carried out by a professional auto technician. If you are not comfortable performing this procedure, it is recommended to seek assistance from a reputable auto repair shop.
