To use epoxy adhesive, first clean the surface of the dash where you will be applying the adhesive. Then, mix the two parts of the adhesive according to the package directions. Once the adhesive is mixed, apply it to the dash and press the warped piece of trim back into place. Hold the trim in place for a few minutes until the adhesive has set.
To use silicone adhesive, first clean the surface of the dash where you will be applying the adhesive. Then, apply the adhesive to the dash and press the warped piece of trim back into place. Hold the trim in place for a few minutes until the adhesive has set.
Once the adhesive has set, you can use a heat gun or hair dryer to warm up the dash. This will help to cure the adhesive and make it even stronger.
Here are some additional tips for securing a warped car dash:
* Make sure that the surface of the dash is clean and dry before you apply the adhesive.
* Apply the adhesive evenly to the surface of the dash.
* Press the warped piece of trim back into place firmly and hold it in place for a few minutes until the adhesive has set.
* Use a heat gun or hair dryer to warm up the dash after the adhesive has set.
* Be careful not to use too much adhesive, as this can make it difficult to remove the warped piece of trim later on.
