1. Locate the diagnostic connector under the dashboard on the driver's side.
2. Connect a jumper wire between the "CG" and "TC" terminals of the diagnostic connector.
3. Turn the ignition switch to the "ON" position, but do not start the engine.
4. The airbag light should start blinking. Count the number of times it blinks.
5. Turn the ignition switch to the "OFF" position.
6. Disconnect the jumper wire from the diagnostic connector.
7. Start the engine and let it idle for a few minutes.
8. The airbag light should turn off.
Note: If the airbag light does not turn off, or if it starts blinking again, there may be a problem with the airbag system. In this case, you should have the vehicle inspected by a qualified mechanic.
