2. Remove the steering column cover. There are usually two screws that hold the cover in place.
3. Locate the ignition key switch. It is usually located on the right side of the steering column.
4. Remove the electrical connector from the ignition key switch. There is a small tab that you need to press to release the connector.
5. Unscrew the two screws that hold the ignition key switch in place.
6. Pull the ignition key switch out of the steering column.
7. Install the new ignition key switch.
8. Reattach the electrical connector.
9. Screw in the two screws that hold the ignition key switch in place.
10. Replace the steering column cover.
11. Reconnect the battery.
Here are some additional tips for removing the ignition key switch on a 1998 Chevrolet truck:
* If you have difficulty removing the steering column cover, you may need to use a pry bar.
* Be careful not to drop the screws that hold the ignition key switch in place.
* If you are replacing the ignition key switch, make sure that it is the correct part for your truck.
* If you have any questions about how to remove the ignition key switch, you can always consult a professional mechanic.
