Tools and Materials:
- Replacement side mirror (matching your vehicle's model and year)
- Phillips-head screwdriver
- Flat-head screwdriver or trim removal tool
- Socket set or wrench
Instructions:
1. Remove Mirror Glass:
- Gently pry the mirror glass loose from the housing using a flat-head screwdriver or trim removal tool. Be careful not to break the glass.
2. Unscrew the Mirror:
- Locate the screws that hold the mirror assembly to the door panel. There might be two or more screws, depending on your model.
- Use a Phillips-head screwdriver to remove these screws.
3. Disconnect Electrical Connectors:
- Before completely removing the old mirror, look for any electrical connectors attached to it.
- Disconnect these connectors by gently pressing the release tabs and pulling the connectors apart.
4. Remove Old Mirror Assembly:
- Once all screws and connectors are disconnected, lift and pull the mirror assembly out of its housing.
5. Prepare Replacement Mirror:
- Transfer the mounting plate and any necessary components (like turn signal indicators) from the old mirror to the new one if required.
6. Install New Mirror:
- Position the new mirror assembly in place, aligning it with the screw holes on the door panel.
7. Screw in the New Mirror:
- Use the Phillips-head screwdriver to install the screws that secure the mirror to the door panel.
8. Reconnect Electrical Connectors:
- If your mirror has electrical features like power adjustment or turn signals, reconnect the electrical connectors you disconnected earlier.
9. Reattach Mirror Glass:
- Gently press the replacement mirror glass back into the housing until it's securely fastened.
10. Test Mirror Functions:
- Adjust the mirror and test its functions, such as power adjustment or heating, if applicable.
That's it! You have successfully replaced the side mirror on your 1996 Civic. Remember to follow these steps on both the driver and passenger sides if needed. Additionally, refer to your vehicle's repair manual for model-specific instructions and safety guidelines.
