Materials Needed:
- Replacement brake light bulbs (check your vehicle's owner's manual for the correct bulb type)
- Socket wrench or Phillips-head screwdriver
- Pliers
1. Park your car in a safe location and engage the parking brake. Make sure the car is in Park (P) or Neutral (N) if it's a manual transmission.
2. Locate the brake light assembly. The brake lights are located in the rear of your Sentra, on either side of the trunk lid.
3. Open the trunk. You may need to use the key or the trunk release lever inside the car to do this.
4. Remove the access cover. There is an access cover on the inside of the trunk that covers the brake light bulbs. Use a flat-head screwdriver or pry tool to gently pry open the cover.
5. Identify the brake light bulb socket. The brake light bulb is located in a socket behind the access cover.
6. Turn the bulb socket counterclockwise. This will loosen the bulb socket and allow you to remove it.
7. Remove the old bulb from the socket. Pull the old bulb straight out of the socket.
8. Insert the new bulb into the socket. Push the new bulb into the socket until it locks into place.
9. Turn the bulb socket clockwise to secure it. Tighten the bulb socket until it is snug.
10. Repeat steps 5-9 for the other brake light.
11. Replace the access cover. Snap the access cover back into place.
12. Close the trunk and test the brake lights. Press the brake pedal to ensure that both brake lights are working properly.
Note: Always refer to your vehicle's owner's manual for specific instructions and safety guidelines related to replacing light bulbs.
