- Wrench set
- Socket set
- Jack and jack stands
- Safety glasses
- Gloves
Instructions:
1. Park your vehicle on a level surface and engage the parking brake.
2. Locate the starter. The starter is typically located on the lower passenger side of the engine, near the transmission. It is a cylindrical-shaped component with a solenoid (a small, cylindrical device) attached to it.
3. Disconnect the negative battery cable. This is a safety precaution to prevent the engine from starting while you are working on it.
4. Jack up the vehicle and support it with jack stands. This will give you better access to the starter.
5. Remove the starter's electrical connections. There will be two electrical connections going to the starter: the positive battery cable and the solenoid connector. Use a wrench to loosen the nuts or bolts that hold these connections in place, and then disconnect the cables.
6. Remove the starter bolts. There will be two or three bolts that hold the starter in place. Use a socket set to loosen and remove these bolts.
7. Remove the starter. Once the bolts are removed, you can pull the starter out of its housing. Be careful not to drop it.
8. Inspect the starter. Take a close look at the starter to see if there are any obvious signs of damage, such as broken gears or worn brushes. If there is any damage, the starter will need to be replaced.
9. Install the new starter. If the old starter is damaged, you will need to install a new one. To do this, simply reverse the steps that you took to remove the old starter.
10. Reconnect the battery cable. Once the starter is installed, reconnect the negative battery cable.
11. Lower the vehicle and test the starter. Start the engine and make sure that the starter is working properly.
- If the starter is not working properly, you may need to have it tested by a qualified mechanic.
