1. Gather the Necessary Supplies:
- New rear wiper blade (compatible with your Rodeo's model and year)
- Clean cloth
- Mild detergent (optional)
2. Locate the Release Lever:
- Open the rear hatch or trunk of your Isuzu Rodeo.
- Inside the rear cargo area, near the rear window, you'll find the wiper arm assembly.
- Look for a small lever or button located on the wiper arm. This is the release lever.
3. Remove the Old Wiper Blade:
- Press the release lever toward the windshield to release the old wiper blade.
- Once released, gently lift the wiper blade up and off the wiper arm.
4. Clean the Wiper Arm (Optional):
- Use a clean cloth and mild detergent to clean the wiper arm and the area where the old blade was attached.
- This step helps ensure proper operation of the new wiper blade.
5. Prepare the New Wiper Blade:
- Remove the new wiper blade from its packaging.
- Some blades may have a protective cover. Remove this cover before installation.
6. Install the New Wiper Blade:
- Align the hook or connector on the new wiper blade with the arm.
- Push down on the blade until it snaps securely into place.
- Make sure the blade is properly attached and won't come off during use.
7. Test the Rear Wiper:
- Close the rear hatch or trunk.
- Turn the ignition key to the "On" position without starting the engine.
- Engage the rear wiper switch to check if the new blade is working correctly.
8. Adjust the Water Nozzles (if Necessary):
- If the water jets from the rear washer don't spray onto the new blade, you might need to adjust the nozzles slightly.
- Gently move the nozzles until they spray directly onto the wiper blade.
That's it! By following these steps, you can successfully replace the back windshield wiper on your Isuzu Rodeo. If you encounter any issues during the process, consult your vehicle's owner's manual or a professional mechanic for assistance.
