Keep in mind that this guide is general and is not a complete replacement for a professional mechanic. Always consult a professional if you are unsure of your ability to do this job.
Parts Needed:
* New Brake Rotors (2)
* Brake Pads
* Brake Fluid (DOT3)
* Jack
* Jack Stands
* Lug Wrench
* C-Clamp
* Brake Cleaner
* Wire Brush
* Pliers
Tools Needed:
* Socket Set (10mm, 12mm, 14mm, 17mm)
* Flat Head Screwdriver
* Torque Wrench (to 85 ft-lbs)
Instructions:
1. Park the car on a flat surface, put it in 'Park', and turn off the engine.
2. Loosen the lug nuts on both front wheels.
Do this by turning the lug wrench counter-clockwise until the nuts are loose enough to be removed by hand.
3. Lift the front of the car with the jack.
Place the jack under the frame of the car and raise it until the front wheels are off the ground.
4. Place the car on jack stands.
The jack is only meant for lifting and should not be relied on to support the weight of the car while you are working. Jack stands should be placed beside the jack and the car lowered onto the stands.
5. Finish removing lug nuts and remove wheels.
Loosen the lug nuts and remove the lug nuts completely. Remove the wheels by pulling them straight off the hub.
6. Remove the old brake pads.
Use a flathead screwdriver to pry them out of their holders on either side of the rotor.
7. Remove the old brake pads from the caliper.
Use a C-clamp to compress the piston in the caliper and remove the brake pads.
8. Clean the rotor.
Use the wire brush to clean the old brake pad material off the rotor.
9. Apply brake cleaner.
Spray brake cleaner onto the rotor to remove any grease or dirt that may have accumulated.
10. Install new brake pads and rotors.
Place the new brake pads into the caliper and slide the new rotors onto the hub.
If you are unable to slide the rotors on by hand, you may need to tap them with a rubber mallet.
11. Reinstall the lug nuts and wheels.
Loosely reinstall the lug nuts and lower the car so the wheels are resting on the ground. Tighten the lug nuts by hand as much as you can.
12. Double-check your work.
Ensure the lug nuts are tightened securely and the wheels are properly installed.
13. Top up brake fluid reservoir.
Remove the cap of the brake fluid reservoir and add enough brake fluid (DOT3) to bring the level back up to 'Full'.
14. Test brakes.
Start the car and press the brake pedal several times to ensure that the brakes are functioning properly.
It's important to take your time and do this task correctly. If done incorrectly, you could cause damage to your brakes or cause an accident. If you are unsure of your ability to do this job, it is highly recommended that you take your vehicle to a professional mechanic.
