Auto >> AutoSPT >  >> Auto Repair

How do you remove the wiper blade from motor?

1. Locate the wiper blade assembly. The wiper blade assembly is located on the front of the vehicle, beneath the windshield.

2. Press the release tab. There is a small release tab on the side of the wiper blade assembly. Press this tab to release the wiper blade.

3. Pull the wiper blade off the motor. Once the release tab is pressed, you can pull the wiper blade off the motor.

4. Remove the old wiper blade. Once the wiper blade is removed from the motor, you can remove the old wiper blade by pulling it off of the wiper arm.

5. Install the new wiper blade. To install the new wiper blade, simply slide it onto the wiper arm until it snaps into place.

6. Test the wiper blades. Once the new wiper blades are installed, test them to make sure they work properly.

Auto Repair
On my 2003 Chevy suburban the wiper blades stop when you turn off switch? How do you replace your suburban rear bumper?
Car Care
Where can one purchase Cadillac jackets? How to Use AC Vacuum Pump for Pulling Out the Moisture? How To Keep Cats Off Your Car: The Most Effective Ways
Engine
What is the best tank in world today? How many qts of oil does a 5.7 liter Chevy engine hold?
Electric Car
Where do you buy a heater blower resistor for 2004 Jeep liberty? What type of transmission fluid is needed for a 1991 buick century custom? What kind of fuel does the 2014 Buick Enclave use?
Autopilot
Why does auto page remote starter will sometimes not start vehicle? How do activate the auto light on Renault megane 1.9dic 2005 model?
Car Photos
How many cars did Ford make in 2006? What are motorized blinds? On a 2001 ford explorer what does the cam sensor do?