1. Park your vehicle on a level surface and apply the parking brake.
2. Locate the rear turn signal assembly. It is located on the rear of the vehicle, near the tail light.
3. Use a flathead screwdriver to remove the two screws that hold the turn signal assembly in place.
4. Once the screws are removed, gently pry the turn signal assembly out of the vehicle.
5. Disconnect the electrical connector from the back of the turn signal assembly.
6. Remove the old turn signal bulb by turning it counterclockwise.
7. Install the new turn signal bulb by turning it clockwise until it is secure.
8. Reconnect the electrical connector to the back of the turn signal assembly.
9. Gently pry the turn signal assembly back into place in the vehicle.
10. Replace the two screws that you removed in step 3.
11. Test the turn signal to ensure that it is working properly.
Tips:
- Be careful not to drop the screws or the turn signal assembly.
- If the turn signal bulb is difficult to remove, you can use a pair of pliers to gently grip and turn it.
- Make sure that the new turn signal bulb is the correct type for your vehicle.
