* Replacement starter
* Socket set
* Wrench set
* Screwdriver
* Safety glasses
* Gloves
* Jack and jack stands
Instructions:
1. Park your car in a safe location, and turn off the engine. Engage the parking brake and chock the wheels.
2. Locate the starter. The starter is located on the passenger side of the engine, near the bottom. It is a cylindrical-shaped object with two electrical terminals on the top.
3. Disconnect the battery. This will prevent you from accidentally starting the engine while you are working on the starter. To disconnect the battery, use a wrench to loosen the negative terminal (marked with a "-") on the battery.
4. Remove the air intake hose. The air intake hose is connected to the throttle body on the top of the engine. To remove it, use a screwdriver to loosen the hose clamps and then pull the hose off of the throttle body.
5. Remove the starter bolts. There are two bolts that hold the starter in place. Use a socket wrench to loosen the bolts and remove them.
6. Remove the starter. Once the bolts are removed, you can remove the starter by lifting it up and out of the engine compartment.
7. Install the new starter. Place the new starter into the engine compartment and line it up with the bolt holes. Insert the bolts and tighten them with a socket wrench.
8. Reattach the air intake hose. Connect the air intake hose to the throttle body and tighten the hose clamps.
9. Reconnect the battery. Connect the negative terminal (marked with a "-") to the battery.
10. Start the engine and test the starter. Turn the key in the ignition to start the engine. The starter should engage and turn the engine over.
Note: If you are not comfortable performing this repair yourself, you can have it done by a qualified mechanic.
