:Prepare the scooter:
1. Park the scooter and turn off the engine.
2. Disconnect the negative terminal of the battery to avoid any electrical damage during the process.
3. Use proper tools and a suitable workspace.
:Disassemble the clutch:
4. Locate the clutch cover on the left side of the engine.
5. Remove the bolts holding the clutch cover using the appropriate wrench. Be careful not to lose any bolts.
6. Once the clutch cover is off, you'll see the clutch assembly.
:Replace the clutch:
7. Inspect the clutch plates and friction material. Replace them if they are worn out or damaged.
8. Remove the pressure plate by unbolting the nuts holding it in place.
9. Remove the old clutch plates and springs.
10. Install the new clutch plates, alternating between friction plates and steel plates. Make sure the friction material faces the correct direction.
11. Lubricate the plates with the recommended oil or grease.
12. Reinstall the springs and the pressure plate. Tighten the nuts evenly to the specified torque.
:Reinstall the clutch cover:
13. Place the clutch cover back onto the engine. Make sure the gasket is properly seated to avoid leaks.
14. Reattach the bolts and tighten them securely.
:Reconnect the battery:
15. Reconnect the negative terminal of the battery.
:Test the clutch:
16. Start the scooter and let it idle.
17. Shift gears and observe if the clutch engages smoothly without slipping.
Remember that this is a simplified overview, and the actual procedure might vary slightly based on the exact model year and variant of the Peugeot Speedfight. It's important to refer to the manufacturer's service manual or seek assistance from a qualified mechanic if you're not experienced with working on scooters.
