Auto >> AutoSPT >  >> Electric car

What are the Torque specs for 1966 326 rear main-pontiac motor?

The torque specifications for a 1966 326 rear main-Pontiac motor are as follows:

Main bearing caps: 55-65 ft-lbs

Connecting rods: 40-45 ft-lbs

Cylinder head bolts: 60-70 ft-lbs

Intake manifold bolts: 20-25 ft-lbs

Exhaust manifold bolts: 25-30 ft-lbs

Water pump bolts: 15-20 ft-lbs

Oil filter adapter: 18-22 ft-lbs

Fuel pump: 15-20 ft-lbs

Distributor: 10-12 ft-lbs

Generator: 25-30 ft-lbs

Starter: 35-40 ft-lbs

Flywheel bolts: 70-80 ft-lbs

Please note that these specifications are for reference only and may vary depending on the specific engine application and condition. Always consult a reliable source or workshop manual for the exact torque specifications for your particular engine.

Auto Repair
How do you replace valve cover gaskets in 2000 catera? How do you Replace clutch master cylinder 19995 Chevy truck?
Car Care
Why You Should Never Skip a Tire Rotation Can you get a loan from bank to purchase car? Tips to Help Keep Your Car on the Road for a Long Time
Engine
Will a 2008 ultra classic rear wheel fit 2005 classic? How much trouble is it going to be put a 1992 3.9 engine into 1989 Dodge Dakota?
Electric Car
If someone else hit your parked vehicle? What does it mean when the oil gauge says is low and light on but there enough in car? Where is heater blower resistor on a seat ibiza 54 plate 1.1?
Autopilot
What is the cheat code for mx vs ATV reflex? The Driverless Car Timeline
Car Photos
Where is the clutch located on a 88 Honda? Where can you find a vacuum diagram for 1980 Mercedes Benz 240d? Does the placement of wheels on a car change speed car?