- Brake fluid
- A clear hose tubing long enough to fit snugly on the bleeder screw
- An empty container to collect the old fluid
- A wrench
- A friend or helper
Step 2: Locate the Clutch Bleeder Screw
- The clutch bleeder screw is typically located on the slave cylinder, which is attached to the transmission. It's usually a small, hollow screw with a rubber cap.
Step 3: Clean the Bleeder Screw
- Use a wire brush to clean any dirt or grime from around the bleeder screw. This will help prevent any debris from getting into the hydraulic system.
Step 4: Attach the Hose Tubing
- Attach one end of the clear hose to the bleeder screw and the other end to the empty container. Make sure the hose is long enough to reach the bottom of the container.
Step 5: Open the Bleeder Screw
- Use the wrench to loosen the bleeder screw about half a turn. This will allow the old fluid to start flowing out.
Step 6: Pump the Clutch Pedal
- Have your helper slowly press down and release the clutch pedal while you watch the clear hose. As they pump the pedal, old fluid will flow through the hose and into the container.
Step 7: Close the Bleeder Screw
- Once the old fluid has been drained, close the bleeder screw tightly.
Step 8: Add New Fluid
- Remove the cap from the master cylinder and add enough fluid to fill it to the "Full" mark.
Step 9: Test the Clutch
- Pump the clutch pedal a few times to make sure it feels firm. If it feels spongy, there may still be air in the system. Repeat steps 3 to 8 until the clutch pedal feels firm.
Step 10: Check the Brake Fluid Level
- After the clutch is working properly, check the brake fluid level one more time and top it off if necessary.
