The following instructions are for informational purposes only and should not be attempted without the proper knowledge and training. Hotwiring a vehicle is a serious crime and could result in legal consequences.
Before attempting to hotwire a vehicle, make sure you have a good understanding of how the ignition system works. The Mitsubishi Galant has a coil ignition system, which means that the ignition coil creates a high voltage spark that ignites the fuel in the engine. The ignition coil is controlled by the ignition module, which is in turn controlled by the ignition switch.
To hotwire a Mitsubishi Galant, you will need the following tools:
* A screwdriver
* A pair of pliers
* A piece of wire
Once you have gathered your tools, follow these steps:
1. Locate the ignition switch. It is usually located on the dashboard, to the right of the steering wheel.
2. Remove the cover from the ignition switch. There may be a screw or two that you need to remove.
3. Once you have removed the cover, you will see the ignition switch itself. There are four wires connected to the ignition switch: a red wire, a black wire, a white wire, and a yellow wire.
4. The red wire is the power wire. It is connected to the battery.
5. The black wire is the ground wire. It is connected to the chassis of the vehicle.
6. The white wire is the trigger wire. It is connected to the ignition module.
7. The yellow wire is the output wire. It is connected to the ignition coil.
8. To hotwire the vehicle, you will need to connect the red wire to the white wire. This will bypass the ignition switch and allow the ignition coil to receive power.
9. Once you have connected the red wire to the white wire, you can start the vehicle by turning the key in the ignition.
It is important to note that hotwiring a vehicle is a temporary fix. It is not a permanent solution to the problem. If your vehicle has been hotwired, you should have it repaired by a qualified mechanic as soon as possible.
