- Screwdriver
- Pliers
- New Injection Pump Position Sensor
Instructions:
1. Disconnect the car's battery to prevent electrical shock.
2. Locate the injection pump position sensor. It is usually mounted on the side of the injection pump.
3. Loosen the screws holding the sensor in place. Be careful not to drop the screws.
4. Gently pry the sensor out of the injection pump.
5. Transfer any gaskets or seals from the old sensor to the new sensor.
6. Insert the new sensor into the injection pump.
7. Tighten the screws that hold the sensor in place.
8. Reconnect the battery.
9. Start the car and check for leaks.
